Used vinyl · For sale on Vinted IT / EN
Guides

33 or 45 rpm: differences, formats and how to tell them apart

A turntable has a selector with two numbers: 33 and 45. They make the record spin at the speed it was cut for. Get it wrong and the music sounds too slow and low, or too fast and high.

By the Soul Records team18 November 20263 min readLeggi in italiano →
Fig. 1 · [Photo: a 33 and a 45 side by side]

What 33 and 45 mean

The two numbers are the revolutions the record makes per minute: 33⅓ rpm for the first and 45 rpm for the second. On the turntable selector you’ll usually see 33 and 45, or 33 RPM and 45 RPM.

The most common formats

  • ·LP, 12 inches (about 30 cm): the album format, usually at 33⅓ rpm.
  • ·Single, 7 inches (about 17 cm): usually one track per side, at 45 rpm.
  • ·EP and maxi single, 7 or 12 inches: can be 33 or 45 rpm, depending on the release.
  • ·78 rpm, 10 inches: older records, made of shellac rather than vinyl.

Differences in sound and playing time

A 33 rpm LP usually holds 20 to 25 minutes of music per side. A 7-inch 45 holds much less, usually three or four minutes per side.

On a record of the same size, at 45 rpm the groove moves faster under the stylus and leaves less room for music. That’s why some reissues made for careful listening are released at 45 rpm across several discs per album: many enthusiasts prefer them for the extra detail. The trade-off is flipping sides more often.

The right speed is the one on the label, not the one that “sounds” better.

How to tell which speed to play a record at

The safest way is to read the centre label: it usually says 33 RPM or 45 RPM. If it doesn’t, check the front and back of the sleeve.

If there’s no indication, the size gives you a general guide:

  • ·12 inches: usually 33 rpm.
  • ·7 inches: usually 45 rpm.
  • ·10 inches: can be 33, 45 or 78 rpm.

These are general rules, not absolute ones. If you play a record at the wrong speed you’ll notice right away: voices too slow and deep, or too fast and high. It won’t damage the record, but it’s best to stop and switch.

Exceptions worth knowing

  • ·Some 12-inch records are cut at 45 rpm, especially maxi singles and audiophile reissues.
  • ·Some 7-inch records, certain EPs in particular, are cut at 33 rpm.
  • ·Many 45s have a large centre hole: to play them you need an adapter that sits on the platter.
What about 78s?

78 rpm records are much more fragile and need a suitable stylus and a turntable with a 78 speed. Don’t play them with a standard vinyl stylus.

How to change speed on a turntable

On most turntables a selector or button is all you need. On some belt-drive models you have to move the belt to another pulley under the platter: check your turntable’s manual.

Stop the platter before changing speed. And if you buy a used record, remember to clean it before playing it: dirt and the wrong speed are the two most common reasons a record “sounds bad”.

All our records
are on Vinted.

View profile ↗